21-12-2006, 02:22 AM
Fra Golmatic hjemmeside
The remanufactured MAUSER M 98 Action for standard calibres
(with double square bridge - without thumb notch)
We manufacture the Mauser M 98 standard action due to the original drawing of Paul Mauser from the early thirties. All MAUSER patents are considered.
We made the following modernizations :
We reduced the bore for the firing pin from 2mm to 1,7mm because of to take into consideration the higher gas pressure of modern cartidges.
We extended the external diameter of the bolt about 0,2mm.
For to guarantee an excellent bolt slide, we reduced the stipulated case tolerance of the bolt about 50%.
For to guarantee a higher safety of the spring, the extractor is allongated about 17mm.
The firing pin nut is delivered with close nose. Therefore also modern shotgun triggers can be installed.
Due to the design of the latest original MAUSER civil versions, we made a stud on the backside of the clearance for the bolt handle which serves as an additional guide and safety for the chamber.
Free selection of the material for the breech case : anealed swiss high-tensile steel with tensile strength between 900 and 1100N/qmm, or a modern high power chrome-manganese steel
The action is prepared for scope mount and is in the standard delivered with the original MAUSER bolt sleeve and Recknagel shotgun trigger
Kære Tikka 9,3-62
Med alle disse forbedringer, hvad er der så tilbage af en std.Mauser?
Bortset fra at den ikke er koldhamret, kunne det jo være en reklame for Winchester, Ruger, Kimber, Brno etc.
Vi kan ikke alle være bedste venner, men jeg synes din tone er blevet
personfikseret istedet for våbenfikseret!
Hilsen Søren med Tikka 590 LH-270WSM,338WSM,6,5x55 BCS [8D][8D]
The remanufactured MAUSER M 98 Action for standard calibres
(with double square bridge - without thumb notch)
We manufacture the Mauser M 98 standard action due to the original drawing of Paul Mauser from the early thirties. All MAUSER patents are considered.
We made the following modernizations :
We reduced the bore for the firing pin from 2mm to 1,7mm because of to take into consideration the higher gas pressure of modern cartidges.
We extended the external diameter of the bolt about 0,2mm.
For to guarantee an excellent bolt slide, we reduced the stipulated case tolerance of the bolt about 50%.
For to guarantee a higher safety of the spring, the extractor is allongated about 17mm.
The firing pin nut is delivered with close nose. Therefore also modern shotgun triggers can be installed.
Due to the design of the latest original MAUSER civil versions, we made a stud on the backside of the clearance for the bolt handle which serves as an additional guide and safety for the chamber.
Free selection of the material for the breech case : anealed swiss high-tensile steel with tensile strength between 900 and 1100N/qmm, or a modern high power chrome-manganese steel
The action is prepared for scope mount and is in the standard delivered with the original MAUSER bolt sleeve and Recknagel shotgun trigger
Kære Tikka 9,3-62
Med alle disse forbedringer, hvad er der så tilbage af en std.Mauser?
Bortset fra at den ikke er koldhamret, kunne det jo være en reklame for Winchester, Ruger, Kimber, Brno etc.
Vi kan ikke alle være bedste venner, men jeg synes din tone er blevet
personfikseret istedet for våbenfikseret!
Hilsen Søren med Tikka 590 LH-270WSM,338WSM,6,5x55 BCS [8D][8D]
"Once upon a time in the West"